loading
reading
writing
saving
searching
1986 Boston Whaler Revenge 22 WT - $25,000 (Lopez)
boat type:
small outboard/fishing
propulsion type:
power
condition:
excellent
length overall (LOA):
25
make / manufacturer:
Boston Whaler
model name / number:
Revenge 22 WT
year manufactured:
1986
QR Code Link to This Post
22’ AWL, 25’ LOA
POWER
Single Honda BF225 4 Stroke – Low Hours, Well Maintained, Runs Beautifully
Newer Yamaha 9.9HP 4 Stroke Kicker, Almost No Hours, Used only as emergency Aux Power.
UPGRADES/ADDITIONS
•
Hydro Shield Hydro Foil and 5 Blade SS Prop on Honda for better power, ease to plane, and efficiency.
•
Life Cell Float-Off Emergency Flotation and Ditch Kit Mounted to Boat.
•
Custom Built U-Shaped rear seating made from HDPE and Mahogany. Seats have custom cushions and all hinge up for access to underneath.
•
Flush floor mounts for cooler or other storage box.
•
New AGM batteries, House and Starter, with Blue Sea system and Switch.
•
New Noco Genius Tandem battery maintainer installed on boat.
•
Additional aux bilge pump wired and piped for use as wash down, or flexible aux bilge pump.
•
Hardtop with 4 rod holders, dome light
•
New navigational lights
•
New cabin lights
•
New cabin upholstery, cushions, and bulkhead
•
New porthole windows, new hatches in Cabin
•
New Windshield gaskets
•
Wind blocks included for driver and passenger side Windshield
•
Riser for captain’s seat
•
New seat covers throughout
•
New gunwales upholstery
•
New battery gauges
•
Lowrance chart plotter/depth/speed/fish-finder
•
Magsafe magnetic charger/holder for cell phone at helm
•
Trailer with surge breaks - new tires, new bearing buddies, extra bearing buddy and caps, full rewire, new lights, new bunk wood and carpet, new strap and hook, new jack stand, chains
•
Topside paint with grip added
•
Elastic storage net at passenger dash
•
New Mahogany companionway ladder with brass hardware and step grip added to varnish
•
New companionway slider custom made with map of SJ Islands carved into it- mahogany.
•
Net storage pouches in companionway and cabin
•
Charging ports at helm and in cabin USB + 12v
•
Convenience handles and hooks added in cabin
Custom back rest cushions added to cabin
•
Custom canvas cover by San Juan Canvas which includes blocking at helm to prevent otters from coming aboard at moorage. Cover is designed to be put on at sea or on land.
•
Additional grab rails added
•
Additional fold down fender cleats added to bow.
COMES WITH
•
Two unused rolls of SeaDeck - enough to cover entire floor and bow
•
Original wood rod holders, SS railing parts, extra new plugs, and brass drain inserts.
•
Fenders and Docking Lines
•
Fluke Anchor Without Rode/Chain
•
2 west system Fiberglass repair kits
•
Wealth of maintenance parts including oil and air filters, belts, water pump impellers and gaskets, all manuals and service records
•
Matched Marine Blue Paint for Hull
PROFESSIONAL WORK DONE
•
Full rewire of boat, with new batteries, New fuse block, wiring terminal, battery switch, aux bilge pump, overhead light in cockpit, new cabin lights and added 12V Charging ports with USB. Done By Roger’s Marine in Portland, OR.
•
Old Gas Tank Removed, Extensive repair and upgrade work done to Bilge/Gas Tank bay under floor, Entire Floor Underside rebuilt, New gas tank and fill lines Installed, Bilge drainage issue (whaler defect) corrected. Done By IMC Marine, Lopez Island.
•
Transom plate professionally installed at motor mount for increased stiffness and security. Entire boat inspected. Done by Schooner Creek Boatworks in Portland, OR.
ISSUES
•
VHF antenna was snapped in a storm while boat was on trailer. Wiring fully intact, repair made with marine epoxy. Antenna works perfectly.
•
Grounding on rocks at idle speed resulted in some minor fiberglass damage along keel. This was thoroughly dried and repaired with safety/longevity in mind, not beauty. Can’t be seen unless you’re under the boat.
•
Gas line for kicker will likely need replacing in a few years. Boat comes with new gas line, clamps and fittings.